Ok
My mate has a cable modem and I am trying to use a belkin router.
It is an NTL cable modem and I cannot get the damn think to work with the ethernet cable.
This is a xmas present so any swift replies would be appreciated.
No ethernet light witht the modem connected by ethernet cable
Help
!!!!
Regards
Beaky
Sorry but its me again !!
- impuresoul2k3
- Senior Member
- Posts: 381
- Joined: Wed Jun 30, 2004 4:11 pm
- Location: Nebraska
Are you using a "cross over" ethernet cable, or are you using a "straight through" cable?
Athlon 3500+
1.5gb PC4200 Ram
nVidia 7600GS
DVD+-R/RW Dual Layer
Segate 160gb HD
Sweet 15" CRT!
Heat
1.5gb PC4200 Ram
nVidia 7600GS
DVD+-R/RW Dual Layer
Segate 160gb HD
Sweet 15" CRT!
Heat
- eGoCeNTRoNiX
- Posts: 7362
- Joined: Wed Oct 23, 2002 12:51 pm
- Location: HELL
- impuresoul2k3
- Senior Member
- Posts: 381
- Joined: Wed Jun 30, 2004 4:11 pm
- Location: Nebraska
Or maybe try a different card
Athlon 3500+
1.5gb PC4200 Ram
nVidia 7600GS
DVD+-R/RW Dual Layer
Segate 160gb HD
Sweet 15" CRT!
Heat
1.5gb PC4200 Ram
nVidia 7600GS
DVD+-R/RW Dual Layer
Segate 160gb HD
Sweet 15" CRT!
Heat
Yes
I Have tried a different cable.
I have the modem connected to the modem port in the router,the router connected to the computer all by ethernet cable.
The belkin installation disk goes right up to the end and cannot find the modem.The ethernet light will not come on on the modem or the router.But the cable modem works fine by usb
Getting close to xmas now and we are a bit concerned.
All help is appreciated
Thanks
Beaks
I Have tried a different cable.
I have the modem connected to the modem port in the router,the router connected to the computer all by ethernet cable.
The belkin installation disk goes right up to the end and cannot find the modem.The ethernet light will not come on on the modem or the router.But the cable modem works fine by usb
Getting close to xmas now and we are a bit concerned.
All help is appreciated
Thanks
Beaks
- eGoCeNTRoNiX
- Posts: 7362
- Joined: Wed Oct 23, 2002 12:51 pm
- Location: HELL
I had this problem at one time, but it was the NIC in the computer that wasn't enabled or connecting to the router.. So a little different.. Not sure where the error could be, hope you find it! 
eGo
eGo
PM before Email People!!
Heat Under eGoCeNTRoNiX
Who Farted? BEANIE!!!
!Welcome to the United States of the Offended!
Heat Under eGoCeNTRoNiX
Who Farted? BEANIE!!!
!Welcome to the United States of the Offended!
- eGoCeNTRoNiX
- Posts: 7362
- Joined: Wed Oct 23, 2002 12:51 pm
- Location: HELL
NIC = Network Interface Card.. The card that your ethernet cable hooks up to on the computer. If not properly enabled, the software will not see the router and give you problems. GL
eGo
eGo
PM before Email People!!
Heat Under eGoCeNTRoNiX
Who Farted? BEANIE!!!
!Welcome to the United States of the Offended!
Heat Under eGoCeNTRoNiX
Who Farted? BEANIE!!!
!Welcome to the United States of the Offended!