Celermine 566 @ 994

LutaWicasa · Post by **LutaWicasa** » Thu Mar 08, 2001 3:08 pm

Well I managed to get her up to 993.92 MHz. She's a Cel. 566 Cbo SL46T. This is at 2.0v and a temp of 37-38c. Ain't stable yet but a little burn-in, some tweakin'......

She'll post at 1054 but stops after DMI verification, just sits there her lttle cursor blinking.

hammer01 · Post by **hammer01** » Thu Mar 08, 2001 3:11 pm

Dat's very nice LW, and I was pretty damned pleased with my 566@901. Excellent job.

vortex · Post by **vortex** » Thu Mar 08, 2001 4:56 pm

If I was that close, I would be really itchy to break 1GHZ (unfortunately I am not!)... Did you give it a try with a smaler step than this 1045Mhz? What about your temps, is she running hot? By how much did you increase the voltage?

[Edited by vortex on 03-08-2001 at 04:59 PM]

LutaWicasa · Post by **LutaWicasa** » Thu Mar 08, 2001 5:18 pm

Temps are ok.Idle at 35c and load at 38c. That should be dropping a bit soon, as I'm supposed to have a Delta on the way to mount on my Alpha. No I can't take a smaller FSB increment. Old BX6r2 goes from 117 to 124 FSB. Stock voltage is 1.50 and I upped it to 2.0v. If I could increase the volt further, this may help with stability. Won't even worry about that until I get some better cooling. Thinking about going wet

GreenTurtle · Post by **GreenTurtle** » Sat Mar 17, 2001 1:26 pm

2V? Are you out of your mind?

LutaWicasa · Post by **LutaWicasa** » Sat Mar 17, 2001 1:30 pm

I'm a little loose in the noodle. I've seen guys running 2.1v and slightly higher. So long as she's cool and not gettin' hinky, its alright.