desk top problems

Discussions about anything Computer Hardware Related. Overclocking, underclocking and talk about the latest or even the oldest technology. PCA Reviews feedback
Post Reply
gatorkiller
Goober Member
Posts: 4
Joined: Thu Jul 13, 2006 7:58 pm

desk top problems

Post by gatorkiller »

ok, problem started maybe after bad weather. i could'nt get on internet.( I have bellsouth dsl.) I checked and the green lights on back of my compter where internet cable plugs in, they are not working. Since i built this computer i dissassembled to check mb for a bad spot, didnt find one. I put it back together, thecomputer comes on, but no signal to monitor or key board. I checked connections many times. Its a p-4 2.8. Abit IS7 MB, 1 gig Corsair ram, Radeon 9800 PRO and Maxtor 120 hd. any ideas? tks
theophilusmousse
Senior Member
Posts: 155
Joined: Fri Feb 11, 2005 10:36 am
Location: Valpo

Post by theophilusmousse »

I hate to say it, but it sounds like your mb is fried. I assume you are using a surge protector, but keep in mind than anything connnected to your computer must go through a surge protector also. If your dsl modem is pluged into the wal, or even if it is plugged straight into the house line, that can provide a path for voltage surges.

If you have a spare power supply around, you could try that, it could have been taken out instead of the mb...

I once lost a computer to lightning... then it turned out that only the modem was fried, and am on that computer now.

Hope this helps
Run, run, run, as fast as you can...
you can't catch me, I'm the Stinky Cheese Man.
User avatar
ZYFER
Posts: 2137
Joined: Thu Nov 07, 2002 4:10 pm
Location: Tampa Bay, Florida

Post by ZYFER »

Lightning is quite hazardous, I got a lightning strike that took out my modem, router, network card, motherboard, power supply and one hard drive. All devices were hooked to a surge protector, including the modem's cable line. One thing you need to know is that a surge protector isn't going to stop lightning, it will go through popping that surge protector along with other things.
When all else fails, replace the user.
Post Reply