Help, Case lights!

iranintoavan · Post by **iranintoavan** » Thu Jan 22, 2004 3:28 pm

I purchesed a X-Dreamer II case and with in a week 3 of the 6 front lights do not work, I opened up the case and checked and none of the wires are unpluged or anything but I did notice that one of the cables comming from the lights was pulled very tight (it was like that when I got the case). What should I do, I need my front lights to work!

PS: I posted this here instead of Mods because I will get a quicker responce here, so please do not move my thread.

smb · Post by **smb** » Thu Jan 22, 2004 4:15 pm

maybe your light burn out already. make sure you have them connected correctly (+) to (+)..etc.etc.

blade · Post by **blade** » Thu Jan 22, 2004 4:29 pm

So the lights did work at first? If so, then check the wires to and from each light. One or two may not be making contact. I had that happen with a case where the wires were too tight, I had to re-attach them. You may need to carefully remove the front bezel.

Or rma the case.

iranintoavan · Post by **iranintoavan** » Thu Jan 22, 2004 4:36 pm

Or rma the case.

Whats that

blade · Post by **blade** » Thu Jan 22, 2004 4:41 pm

rma = send it back. But you need to contact the place you purchased it from first. It's possible they may do it with just the bezel, or send it first to you. Just ask them, if you aren't able to fix it.