power supply ends

VooDoo · Post by **VooDoo** » Fri Dec 05, 2003 5:33 pm

i saw them once but i for got ware
the ends of the power supply can be removed

i want to put florest ends on but i cant remember

ware i saw them

i also need a tool to remove them

does anyone have one i can barrow

me

eGoCeNTRoNiX · Post by **eGoCeNTRoNiX** » Fri Dec 05, 2003 9:08 pm

But there hasn't been much added to the case modding section , so going back a page or two and looking would probably yeild your answers.. Also, to remove the molex, just use a jewlers screw driver to push in the tabs on both sides of the pins..

eGo

NascarFool · Post by **NascarFool** » Fri Dec 05, 2003 9:44 pm

I bought a molex pin tool from SVC for $7.95. It doesn't work that good. I found that there are two sizes of this tool available and SVC sells the bigger one. I don't remember the size of the tools.

Badmojo · Post by **Badmojo** » Sat Dec 06, 2003 12:11 am

I use a small pin or what fits in the molex.
for atx the pins are (if you look close enough)Here----> [ ] <-----and here on the flat ends, dont forget to bend them out when slipping them back in

VooDoo · Post by **VooDoo** » Thu Dec 11, 2003 3:46 pm

ebay rules again

i found my uv moles ends

me

VooDoo · Post by **VooDoo** » Thu Dec 11, 2003 4:16 pm

Originally posted by badmojo
I use a small pin or what fits in the molex.
for atx the pins are (if you look close enough)Here----> [ ] <-----and here on the flat ends, dont forget to bend them out when slipping them back in

what about the male ends or is it the same

with the pins an the side

me

eGoCeNTRoNiX · Post by **eGoCeNTRoNiX** » Thu Dec 11, 2003 4:27 pm

VooDoo · Post by **VooDoo** » Thu Dec 11, 2003 4:29 pm

ty

me

PCA Forums

power supply ends

power supply ends

Forgot where that mod is..

It's the same..