Can anyone tell me of a site for the max processor for an Intel CA810 i810

DaMaN · Post by **DaMaN** » Tue Apr 16, 2002 2:35 pm

Intel site says Celeron processors but will a newer >1.0ghz one work?

Will a P3 FCPGA work up to what speed?

I hate Intel's site. Thanks.

~David

MRCOMPUTER · Post by **MRCOMPUTER** » Tue Apr 16, 2002 3:24 pm

The highest chip I was able to run on one was a CII 600 1.5 volt...

DaMaN · Post by **DaMaN** » Tue Apr 16, 2002 5:26 pm

I saw as high as a celeron 700 on a HP Pavilion 6535 (parted from one of these PCs) site

MRCOMPUTER · Post by **MRCOMPUTER** » Tue Apr 16, 2002 5:40 pm

Worked on a 6535 not long ago. It had an 810 chipset board. It was not a CA810. That might be the difference...

DaMaN · Post by **DaMaN** » Tue Apr 16, 2002 9:22 pm

That's right! thanks.

PreDatoR · Post by **PreDatoR** » Tue Apr 16, 2002 11:30 pm

There's 2 or 3 revisions of that board... I had oen of the older revisions and the highest i could go was the 533 PPGA package... The latest revision which Intel should show all this on their site cause this is where i got it from way back them. But it would take the newer Celeron FC-PGA's and P3's.

DaMaN · Post by **DaMaN** » Wed Apr 17, 2002 12:19 am

I am upgrading a system for a co-worker and would hate to buy a processor for nothing if it didn't work for him. What do you reccomend I should go for a celeron or p3 and how high? It has a Celeron 466 now. =/.

PreDatoR · Post by **PreDatoR** » Wed Apr 17, 2002 12:48 am

If it has a 466 chances are its the first revision of that board. And it will only take up to a 533 PPGA celeron.

http://support.intel.com/support/mother ... ocsupp.htm

Read this list here and figure out which revision the motherboard is. That will tell you what you can put on this motherboard

Depending on which board it is it will accept up to a 850MHz P3 at 100Mhz FSB