Need some help with GF2 Ultra

Silver Bullet · Post by **Silver Bullet** » Sat Mar 31, 2001 11:03 am

I bought a Hercules Prophet II Ultra and am not having much luck with it. In Midtown Maddness there is large flashing textures. On the Hercules site under trouble shooting it says to increase the I/O voltage in your BIOS, it is not suggested to go above 3.5, well my cusl2 is set at 3.4 default with the next setting being 3.6, I don't think I want to change this. It also says make sure your motherboard is suppying enough power to the AGP slot. How do I do this?
Tiger Woods Golf stutters with 3D acceleration on but plays fine with it off???? Of course with it off you don't see any contours or undulations in the landscape.
I have been using a V5 pci bought from Quino that has been a rock but just not fast enough for NASCAR 4, so this is my first AGP card. Any suggestions would be appreciated.

edit: added system specs

P3 800
CUSL2
GF2 Ultra
TB Montego II Quadzilla
256 pc133 Crucial
3Com nic
Linksys nic

greg

[Edited by Silver Bullet on 03-31-2001 at 11:09 AM]

dadx2mj · Post by **dadx2mj** » Sat Mar 31, 2001 11:11 am

Check out http://www.geforcefaq.com maybe you can find some help there. Also did you get rid of all the voodoo drivers maybe they are conflicting with the GeForce drivers

Silver Bullet · Post by **Silver Bullet** » Sun Apr 01, 2001 12:23 am

Thanks dadx2mj,

Great site...I learned alot and have fixed my MTM problem.

I would still like to know how to adjust or at least check the power to my AGP slot. Two trouble shooting forums say to adjust the AGP Aperture...I can't find this in BIOS either. The only problem I have now is some stuttering.

Thanks again,
greg