Problem with USB Keyboard and Mouse: RESOLVED! IDE Drivers!

GuardianAsher · Post by **GuardianAsher** » Thu Jun 15, 2006 12:39 am

I'm running my main rig with a combination Logitech MX700 mouse and wireless keyboard. I started having problems with windows not booting completely. It would either hang on the Windows XP screen, and the little bar would stop moving, or the bar would keep moving, but the Hard Drive would show no activity. After trial and error, I finally traced the problem to the mouse and keyboard's wireless reciever. When I unplug it, Windows boots perfectly. But if it's plugged in when I turn the computer on, it hangs. What could be causing this?

Post by **FlyingPenguin** » Thu Jun 15, 2006 7:00 am

Can't imagine why, unless the keyboard has a stuck key maybe.

Also one misbehaved UBS device can interfere with others. I've often seen a flaky card reader cause that. Try plugging the receiver into a completely different pair of USB jacks (each pair is on a different USB bus which isolates them). Also try unplugging ALL your USB devices except the receiver.

Hope this helps...

eGoCeNTRoNiX · Post by **eGoCeNTRoNiX** » Thu Jun 15, 2006 7:26 am

Yah, I've been using my MXDUO for almost 4 years now with no problems what so ever.. I have even added my MX1000 to the mix with no issues other than not being able to program the special buttons on the keyboard lol..

Post by **MidnightSin** » Thu Jun 15, 2006 1:26 pm

I would say bring it to the store and we would figure it out tomarrow........... but now I dunno.

GuardianAsher · Post by **GuardianAsher** » Thu Jun 15, 2006 2:55 pm

There are no other USB Devices plugged in, and I've tried plugging it in to all 4 pairs of USB jacks. 2 front, 4 motherboard, and 2 on expansion slot. Same response. It's pissing me off >.<

MegaVectra · Post by **MegaVectra** » Thu Jun 15, 2006 4:45 pm

If it just started all of a sudden and there are no other devices attached, I would have to assume that it has bit the dust.

GuardianAsher · Post by **GuardianAsher** » Thu Jun 15, 2006 8:40 pm

Well, if I let Windows boot up, and then plug it in, it works perfectly

MegaVectra · Post by **MegaVectra** » Thu Jun 15, 2006 9:28 pm

Did you try removing all mouse software?

Post by **MidnightSin** » Thu Jun 15, 2006 10:57 pm

Did you check your bios to see if its trying to boot from a usb device along with the drive for some freaky reason? Seriously doubt it but its worth double checking. BTW you gonna show up at the store again?

Post by **FlyingPenguin** » Fri Jun 16, 2006 5:27 am

Has to be a driver issue if it hangs during the XP boot screen. Will it boot into Safe Mode with the receivier connected? If so that's confirming it's either a driver issue or a background app Logitech installed.

If you installed drivers for this keyboard/mouse combo, uninstall it for now (you don't need it for the keyboard to work). You might try uninstalling your USB ports and then letting windows re-detect them.

GuardianAsher · Post by **GuardianAsher** » Fri Jun 16, 2006 12:00 pm

Could the problem be with a conflict between some mouse/keyboard and IDE drivers? The reason I ask is because I remembered a similar issue I had when I first got the board. I would install nVIDIA's IDE drivers, and the comp would stop booting. I just reverted back to the standard IDE drivers, and it boots fine, even with the reciever plugged in. I still have yet to try uninstalling the Logitech background apps, but this seems to have solved my problem. As for Safe Mode, it got to the point where it wouldn't even try to boot, whether normal mode or safe mode, even with the reciever unplugged. So basically, here's where I stand now.

1st Few Days: Computer wouldn't boot into regular mode with reciever plugged in, but would boot into safe mode with reciever plugged in, and normal if reciever wasn't plugged in.

This morning: Computer wouldn't boot into either normal or safe mode with reciever plugged in or unplugged. Through sheer luck, it randomly booted fine on one try. Uninstalled nVIDIA IDE drivers, and computer boots fine with reciever plugged in or unplugged, in either safe or normal mode.

Still can't figure this out. If I have Windows standard IDE drivers installed, won't I lose performance compared to the nVIDIA drivers?

GuardianAsher · Post by **GuardianAsher** » Fri Jun 16, 2006 12:13 pm

Okay, traced the problem. It turns out it's just the IDE drivers, has nothing to do with the keyboard and mouse. I uninstalled Logitech's drivers, and reinstalled nVIDIA's IDE drivers, and it wouldn't boot. Thanks for all of your suggestions and help.

Post by **FlyingPenguin** » Fri Jun 16, 2006 6:22 pm

Thanks for reporting back. Someone in the future might find that useful.

I hate it when people kill threads on other forums when they solve a problem. You never know when someone might come across your thread in a Google search and save his day.

Post by **MidnightSin** » Fri Jun 16, 2006 7:35 pm

Thats way true, alot of times I search for a solution to an issue and find it in a forum somewhere and there has been more than one time where the end of the thread just said "Problem Solved" but no explanation as to how.

Post by **MidnightSin** » Fri Jun 16, 2006 8:32 pm

Ok now since thats solved Josh next question is..

Are you coming back to the store or do I do like today and tell the people that ask for you that you havent been at work for 3 days and we havn't heard from you so we dont know if your coming back.