Does this look okay...?

GuardianAsher · Post by **GuardianAsher** » Sat Dec 24, 2005 1:41 pm

Well, with my new 6800XT, which is nearly two inches longer than my 5600, I had to do a rewiring job on my computer once more. I tried to keep all of the wires out of the way of other things. I found a nice two inch deep, five inch long gap behind the 3.5" drive slots, and I put most of the wires back there. Need some advice.

DoPeY5007 · Post by **DoPeY5007** » Sat Dec 24, 2005 1:51 pm

looks fine

123cool · Post by **123cool** » Sat Dec 24, 2005 1:55 pm

mine looks worse cause of the shielding that enermax uses its really hard to move the wires around.
.

eGoCeNTRoNiX · Post by **eGoCeNTRoNiX** » Sat Dec 24, 2005 1:58 pm

Looks darn good if you ask me.

One of these days I'll get back into my case and clean it up really nice. heh.. When I do, I'll post pictures.

eGo

GuardianAsher · Post by **GuardianAsher** » Sat Dec 24, 2005 2:06 pm

Thanks a lot for the input, means a lot to me ^^ My compy is my baby after all. Also, another question. Is it okay for me to run the HD, Floppy, and CD-ROM all off the same power cable? The PSU is modular, and each wire that comes with it has 3 molex connectors and a floppy connector. To reduce the clutter, I ran all 3 devices off the same cable? Is this safe? Or should I throw in another cable to power the CD-ROM? I put a seperate cable for the video, since the PSU came with one specifically for that. Also, the PSU is a 24-pin BTX plug. The mobo is a 20-pin ATX. It came with an adaptor, but I really didn't think it needed it since the 4 extra pins just hang over anyway. I plugged it in without the adaptor, and the 4 pins are hanging over the left side, near the motherboard. Should I use the adaptor, so the unused pins are further away, or is it okay like this?

MegaVectra · Post by **MegaVectra** » Sun Dec 25, 2005 7:32 am

Looks good, you should see mine.