Page 1 of 1
Posted: Wed Jan 31, 2001 3:06 pm
by Killerbob2000
Ok so i just bought this Duron600mhz from a guy who said he used it and got up too 900mhz overclocking it with the retail HS and fan. I have it noe and i just ordered a Globalwing FOP32-1 HS and fan and i will be using artic silver epoxy. I have a abit kt7w/raid MOBO. This processor is not unlocked anymore (he erased his pencil marks) and i want to know hwo high do you recommend i go and what is a good site that explains how to unlock this processor with the pencil. Thank you
Posted: Wed Jan 31, 2001 3:14 pm
by nexus_7
its super easy. U will se an L1 some where. connect the dots that are across from one and other. vala it is unlocked. 900 should be a Nice start.
Then jack up the FSB. I have my 650 at 963 thats 9.0*107.
Greg
Posted: Wed Feb 21, 2001 4:15 pm
by the FooL
I was the one that sold it.
The pencil marks were off after I cleaned up the
paste before I shipped it to you.
Sorry about that, wasn't expecting to sell to a
newbie.
BTW, I have to send you the certificate and all the rest
that comes with the retail box.
As Greg said, look for the L1 label.
L1 : : : :
then connect each pair (top to bottom)
by running a pencil between the dots a few times.
Make sure to blow on it before checking so you
can be sure of a clean connection.
How permanent is the pencil?
Posted: Sat Feb 24, 2001 3:02 pm
by blackhawk
The conductive pen is used for a more permanent connection. Is that much more difficult other than buying the pen?
Posted: Sun Feb 25, 2001 3:13 am
by rich1er
how long does the pencil/pen method last? I don't want to keep on having to take off the fan to make more pencil marks again... Is there another way to unlock the cpu?