Page 1 of 1
Any NForce board under mATX spec of 9.6"x9.6"?
Posted: Mon Dec 08, 2003 3:08 pm
by Nuts4GTS
Wanting to procure a board for a toolbox PC project an utilize a TBred B 1700+, 2 x 256MB PC2400 DIMMS in dual channel mode. So far the only boards I have found that may have offerings to fit my hacked toolbox are of the SiS 740, KM266/400 flavors. Please advise if you know of a board that might fit the bill...namely 9.75" x 8.5" size limitation
Posted: Mon Dec 08, 2003 3:32 pm
by BillyGoat
Biostar M7NCG is a nice matx board thats the 9.6 x 9.6, I think youl;l have a hard time finding them smaller then that
or the Asus A7N8X-VM in nforce 2 flavor
Posted: Mon Dec 08, 2003 3:53 pm
by Nuts4GTS
yeah..my problem is the narrowness of the toolbox....I am afraid that I am SOL on a NForce solution
does anyone have any of these boards:
Asus A7N8X-VM
Biostar M7NCG
Biostar M7NCG Pro
Chaintech 7NIF2
MSI K7N2GM-L
Shuttle MN31N
If so, could you measure your board and lmk if it is indeed 24.4cm square?
~Nuts
Posted: Tue Dec 09, 2003 8:38 am
by Nuts4GTS
I am thinking that the fact that the NF2 boards have that third DIMM is what is pushing the width...yes?