http://www.amdforums.com/showthread.php ... genumber=1
after searching the net one night I came accross the above forums .pretty much all you need to know on how to fix it is there.there are several versions on how to fix this issue but from my personal experience this one is gonna give you the best success with least frustation. use the 1k ohm pod from radio shack ---> http://www.radioshack.com/product.asp?c ... =271%2D342
with this unit I am able
to adjust my +5 v from 4.75 to 5.4 in like .01 volt increments .I have mine set to a solid 5.1 now and it never drops below 5 .these enermax power supplys are very good units the engineers just did not think about how some of our voltage demands may be higher than others this little mod will fix it right up.Im am very happy with mine now i must say
I was a little hessitant about soldering my ps at first but it turned out to not be that big of deal you only need to release one side of 1 resistor and install the pot. I due recomend that you epoxy your pot in once you solder it to give it some streangth. and also please read through that forum there might be somthing else usefull to you .I hope this helps sombody and HAPPY +5Vs
