post your amd xp overclocks!!

quicksilvr · Post by **quicksilvr** » Thu Dec 02, 2004 1:50 pm

im kinda new at this, so takin it slow....2200 @ 1.94 (13.5X144) and 1.65v temp at around 32C (idle). dont wanna push it till i upgrade the stock cooling.
i got a quick quiestion...should i keep increasing the fsb or bring the multiplier down first?

BillyGoat · Post by **BillyGoat** » Thu Dec 02, 2004 6:49 pm

i slowly find my max fsb , then i back off and find my max speed, then do lots of benchmarking
250 fsb x 10=2500 is faster on my rig then 13*200 @2600 is

quicksilvr · Post by **quicksilvr** » Fri Dec 03, 2004 3:18 am

k thanks....i have a couple more questions, but i dont wanna take the thread off topic, so i'll make a diff one later.

goladith · Post by **goladith** » Sun Jan 02, 2005 10:09 pm

so, a FX-55 wouldn't fall under the catagory of AMD XP would it? lol

PHILO67 · Post by **PHILO67** » Tue Jan 04, 2005 1:04 am

dont really know much but got this to bench tried 177 fsb but crashed during bench then backed it down to 175fsb amd xp2700+

pc mark 2002- at 1024x768
-2275.0 mghz score cpu-6589 mem-3814 hdd-644
fsb 175x13
agp 70
dram 420
cpu volt 1.676 dram v-2.5 agp v-1.5
cpu temp 54c during bench on stock cooling

it felt good from prev bench scored 350 better on cpu bout same on mem test so did i do good???

RubberDuckie · Post by **RubberDuckie** » Tue Jan 04, 2005 10:54 pm

2500+ running at 3200+ with retail HS/F nothing special

zeke_1 · Post by **zeke_1** » Tue Jan 18, 2005 11:09 pm

Originally posted by TruckStuff
Running a 2000+ at 12.5 x 166Mhz (2.1Ghz). XP reports this as a 2600+ even thouch its closer to a 3000+. Just running the retail HSF. I know it could go higher, but my RAM starts to flake out at higher FSBs. Maybe someday I'll put some faster RAM in their and buy a better HSF, but doesn't Doc say you need a 30% increase in CPU speed to "feel" a difference in the system? I doubt I'll be able to squeeze 2.7Ghz out of a 1.6Ghz stock CPU.

ok im a bit of a noob when it comes to this so looking for some help. I have just upgraded to a corsair 512mb ddr 400. at the moment i am running an xp2000+ (1662) the problem is that the max i can get out of the processor is 1680 i am running the memory on the mobo (NF7 v1.x) by SPD (400mhz was stuck to 266 until i turned its to SPD) the processor is a 133 (266) does anyone have any ideas how i can bunk it up a bit? i have an aero 7 lite cooling fan and its rated to Xp3000+ so im sure i should be ablt to get a few more mhz? just nice reach 2.0gz lol

this is how its setup at the moment

133 X 12.5 ( doesnt seem to be able to change from that ) = 1662

thanks again
Zeke_1

k1rby · Post by **k1rby** » Wed Jan 19, 2005 12:46 pm

AMD 2500+ 1.826 Ghz (11.0 x 166FSB) -OvErCloCkEd to- AMD 3200+ 2.20 Ghz (11.0 x 200FSB)

Volcano 12 + Cold Wisconsin Weather = (86F Idle) (115F High Load)

OldMan · Post by **OldMan** » Tue Feb 01, 2005 4:15 pm

IQYHA 0348 SPMW 2600+ Mobile

W/C with DD Maze waterblock. DFI Infiniti Ultra.

This one is for my every day surfin' stuff.

I'll check on another HDD for pics of another 2600+ that runs 3 Ghz for me
under phase-change. It's also an IQYHA 2600+ Mobile. And on a DFI Infiniti
Ultra also.

Have recently built a S754 and a S939 to replace these Socket A units.

Time to move on.

Pops.