Sunbeam Fan Controller

blade · Post by **blade** » Thu Mar 20, 2003 2:38 am

I've had most that are out now and this is by far the best.
http://www.pcabusers.com/reviews/sunbeam/p1.html

Review by PreDatoR

Beware the led's though, they are bright!

PreDatoR · Post by **PreDatoR** » Thu Mar 20, 2003 3:10 am

I received an email from someone who didn't bother to leave their name but they pointed something out and i don't think they clearly understood part of the review. This rheobus you can turn each channel off. The voltage is adjustable from 0 volts all the way up to 12v's. You can clearly run a cold cathode tube off of this bus for the fact that you can turn it OFF! When the CC is on however you will want to run it at the full 12v's or you will be looking at premature failure on the CC with any other voltage below 12v's.

bern · Post by **bern** » Sat Apr 26, 2003 5:00 pm

on the controls does it indicate at what voltage it is set at also does it have any software with it

blade · Post by **blade** » Sat Apr 26, 2003 5:23 pm

bern,

No software comes with it nor is any needed. It also doesn't indicate the voltage when adjusted, but you can clearly see and hear a diference in any fans attached to it.

Welcome to pca

bern · Post by **bern** » Sat Apr 26, 2003 5:29 pm

hi thanks for the prompt reply do you know of any controllers that can indicate what voltage they set at and can be adjusted between 0-12 volts

blade · Post by **blade** » Sat Apr 26, 2003 5:40 pm

You're welcome

This one adjusts the fans from 0-12 volts, plus it can turn them completely off so you can use it to control a cathode also. I haven't seen any fan controllers that actually show the voltage being used, sorry. I don't believe any exist, for now.

bern · Post by **bern** » Sat Apr 26, 2003 5:43 pm

thanks again i going to contact them to see if they ship to uk