PCA Forums

http://www.pcabusers.com/reviews/aeroflow/p1.html

Pretty sweet little cooler you guys should check it out!

Feel free to post any thoughts or questions!

seems like a nice hsf also

the fan......its got 4 motors?
what, like one in each corner?

Yeah there's one on each corner... Found this pic on the net of that fan tore apart. Let me tell ya it has a hell of a lot more power than a standard fan. I slipped and got my finger in it once and it torethe hell out of me

thanks for the pic, explains a lot

I was thinking that the motors were horizontal instead of vertical, but then i couldnt see how the screws would go through it

Help! I bought this fan, it installed very easily. When I booted my computer , it said no CPU fan found. I checked everything and rebooted. I got the same response. The fan was spinning but I assume the feedback was not returning the signal. I had to reinstall the factory fan.... that sucked..... and now am lost as what to do. I know I intalled properly because the factory fan is sending feedback. Maybe the feedback board in the fan? Any Ideas?

Yea i have a question... Where do you go to buy just the fan? i have been looking all over for a place that sells just the fan... but nobody seems to. Also do they make it in a 60mm?

kdc sells it.

and no, presently, only 70mm's are made. I have heard the holes are the same place as the 60mm...I have one sitting here, but im not gana check.

Greg

the holes are 70mm holes greg just checked it against a 60 i have sitting here... Dopey there's an option in the bios to disable the cpu fan warning thing. I can't get mine board to read the RPM from this fan either so i had to disable the warning... after that the comp will run just like normal. i think this fan having 4 motors really screws with the motherboard when sensing the speed of it.

ok thanks... ill just have to make a 60~70mm adapter.