Page 1 of 1
MoBo won't come out.
Posted: Thu Jan 23, 2003 11:43 pm
by the.grunter
I'm trying to remove my motherboard to, among other things, install a new heatsink (Alpha Pal 8045). Unfortunately when unscrewing it i get to the very last screw and it wont come out. I've tried and tried, but it comes out a little, then goes back in. Apparently some problem with the threading. Is there anything you can recommend to help me get it out? I really need to remove it.
Thanks.
Posted: Thu Jan 23, 2003 11:45 pm
by nexus_7
um, try using a needle nose plyers twist and pull.
Welcome to PCA!
Greg
Posted: Thu Jan 23, 2003 11:56 pm
by blade
That happens to me with about any mobo removal. What nexus said is what I always do too.
Welcome to PCA
Another Tip..
Posted: Thu Jan 23, 2003 11:58 pm
by eGoCeNTRoNiX
Try holding the Mobo Standoff from the back side of the mobo with a pair of pliers. I had a screw do this to me and that's how I fixed it.. eGo
Posted: Fri Jan 24, 2003 1:19 am
by FlyingPenguin
All you need to do is pull up on the screw slightly while unscrewing it. Even if you can just get a fingernail under it- once it catches it should back out as long as you don't press too hard on it.