Page 1 of 1
Question about Linksys' web-based management.
Posted: Sat Mar 30, 2002 8:23 am
by Sean
How do you access it if you are using something else (like a Cisco 678 Router) for the DHCP server? I want to configure a few settings on it, and well, I can't access the web-based management because the Cisco Modem gives all the computers in the network an IP address. Anyone know?
Posted: Sat Mar 30, 2002 2:05 pm
by PreDatoR
Your using a Cisco router and a Linksys router?? I hope i read this right but i just got out of bed.... This post didn't make much sense to me...
Posted: Sat Mar 30, 2002 5:00 pm
by Sean
LOL. Yeah, I disabled the DHCP in the Linksys Router because that's what the Cisco was programmed to do.
Posted: Sat Mar 30, 2002 6:54 pm
by MegaVectra
The default IP for the Cisco 678 is 10.0.0.1 and 192.168.1.1 for the Linksys. You need to make sure they are using the same network address scheme.
Posted: Sat Mar 30, 2002 7:49 pm
by Sean
Ok. I will read through my manual on that.
Thanks.
Posted: Sat Mar 30, 2002 11:37 pm
by PreDatoR
Can i ask why you need 2 routers? I'm lost on this as one should do the trick...
Posted: Sun Mar 31, 2002 8:28 am
by Sean
Well, we needed a wireless hub, and we needed a built in switch. So, we got the Linksys WAP + Router and 4 port switch. Than I just disabled the DHCP, because I don't know how to program the Cisco to use the Linksys as the router.