Page 1 of 1
atx ps Power up...?
Posted: Fri Dec 14, 2001 5:22 pm
by nexus_7
How do I make an ATX system Power up right when the PS is eithor turned on or pluged in? is there any easy way? I tried a jumper on the mboard but that didnt work...and thats all I thought of.
Greg
Posted: Fri Dec 14, 2001 9:59 pm
by Celery101
shorting(connecting a wire between) the green wire and a ground wire(any black one) on the motherboard connector will turn the ps on.
Posted: Fri Dec 14, 2001 10:37 pm
by Jim Z
Not really. It requires a momentary short of the PS-ON line to ground, along with sufficient loading on the +5v line to keep it operating.
Posted: Sat Dec 15, 2001 12:09 am
by nexus_7
ok...so can I do it?
Greg
Posted: Sat Dec 15, 2001 1:26 am
by Jim Z
The only way that might work is if your BIOS has a setting in Power Management or Power Up Control called "power on after loss" or something like that. If that's enabled, then if you pull the power cord it should power up when you reinser the cord.
can I ask what you're ultimately trying to accomplish?
Posted: Sat Dec 15, 2001 1:30 am
by nexus_7
well in the Lego case I havent made a power switch...and hte only way I have to turn it on is sort the 2 prongs. it will be pluged into the tv so I would really just like to use the switch on the PS...but it is an OLD ass mboard...epox mvp4-a k6-2 stuff. ill check the bios if I get around to it.
THanks for the idea.
Greg
Posted: Sun Dec 16, 2001 6:20 pm
by nexus_7
did the bios thing and it works just fine. poweres up right when it is pluged in. Excelent and Thanks
Greg
Posted: Sun Dec 16, 2001 11:28 pm
by Jim Z
using the switch on the PS should do it too
Posted: Mon Dec 17, 2001 12:20 am
by nexus_7
yea...butn when you have a $20 CompUSA special you saddly Dont het the lugary of a switch.
Greg