It seems like it's taking way too much force to get the fan wire clip over the screw holes on the vantec tornado 92mmx92mmx38mm. The bottom of the fan clip hits the bottom part of the fan and tends to push the fan off center as you engage the points of the fan clip into the holes.
Should this be happening? The fan clip wires seem to be getting bent. I am worried the kind of force I have to apply to get this thing will eventually bed the fins of the heatsink, they are extremely thin and fragile.
oh and another thing, when I was removing the plastic sticker covering the bottom interface of the heatsink some of the glue from the sticker came off, I cleaned it with isopropyl alcohol so hopefully it'll be okay. One anoth thing there is a small dark cricle on the bottom of the heatsink, on the contact area, very small but noticeable. Think I should return it? I'm not sure what it is but I scrubbed at it hard, couldn't get it off =/
SLK948U and 92mm Vantec Tornado - HELP!
-
Karchiveur
- Golden Member
- Posts: 1431
- Joined: Tue Apr 24, 2001 5:09 pm
- Location: Fraserwood, Manitoba, Canada
- Contact:
