Sold: Desktop Case
Posted: Fri Dec 15, 2000 3:09 pm
This is a nice desktop case that has been fixed up. It took a long time just to locate a desktop case that didn't look like crap and this was the best one I found.

First I'd like to mention a few good additions made to it:
a) Athlon case badge!
b) The inside of the cover (shell) is layered w/ Duramat sound dampening material
c) The front ventilation holes have been carefully drilled out to maximize airflow (they were only partially open before).
d) It will ship in the original box with all original packaging (pamphlet, mounting hardware, screws, standoffs, faceplates, etc)
Negative about the case:
-there are only two 5.25" bays and two 3.5" bays (only one exterior) ...this means that (unless you aren't going to use a floppy) it will only accomodate one hard drive. Other option is seen in photo #1 where a hd is in the upper 5.25 bay
-the lowest hd bay (beneath the floppy) is only usable if the motherboard you have is not that wide (i.e. - my Asus K7M was fine but an Abit KT7 is too wide)
-it doesn't come with a PS (needed it for my new case) but the mounting area is nice and off to the side of cpu (not above).
I am looking for $25 shipped for this case. I think it will cost me ~$15 to ship so that leaves me with $10 net gain (btw I paid $55 shipped [w/o PS] for it). Looking for PayPal payment, it will ship today if deal is finalized before 5pm
[Edited by RacerX on 12-15-2000 at 03:15 PM]

First I'd like to mention a few good additions made to it:
a) Athlon case badge!
b) The inside of the cover (shell) is layered w/ Duramat sound dampening material
c) The front ventilation holes have been carefully drilled out to maximize airflow (they were only partially open before).
d) It will ship in the original box with all original packaging (pamphlet, mounting hardware, screws, standoffs, faceplates, etc)
Negative about the case:
-there are only two 5.25" bays and two 3.5" bays (only one exterior) ...this means that (unless you aren't going to use a floppy) it will only accomodate one hard drive. Other option is seen in photo #1 where a hd is in the upper 5.25 bay
-the lowest hd bay (beneath the floppy) is only usable if the motherboard you have is not that wide (i.e. - my Asus K7M was fine but an Abit KT7 is too wide)
-it doesn't come with a PS (needed it for my new case) but the mounting area is nice and off to the side of cpu (not above).
I am looking for $25 shipped for this case. I think it will cost me ~$15 to ship so that leaves me with $10 net gain (btw I paid $55 shipped [w/o PS] for it). Looking for PayPal payment, it will ship today if deal is finalized before 5pm
[Edited by RacerX on 12-15-2000 at 03:15 PM]