Car HELP

mtg · Post by **mtg** » Fri Apr 24, 2009 10:26 pm

okay so its not a major issue but i miss my clickers working or remotes so on wedneday all is good and then thurday comes and try to unlock my doors with the remote nothing thought it was batteries ... it wasnt tried other remote wasnt the remote so i check out the fuse and it works to so i don't know whats going on any ideas??

FYI i have a 1997 ford explorer limited so if that helps

normalicy · Post by **normalicy** » Sat Apr 25, 2009 7:00 am

I assume that these are factory remotes? Has your Explorer lost power recently? Possible that the the alarm forgot the remotes coding. You may try new batteries anyhow though.

Err · Post by **Err** » Sat Apr 25, 2009 8:44 am

Check the manual. There should be a procedure to have the vehicle re-learn the remotes. You could also have a bad receiver.

I found this: http://www.justanswer.com/questions/1y2 ... rogram-new

Programming

NOTE: All keyless entry remote transmitters must be set at the same time.

To program (or reprogram) the keyless entry remote transmitters into the RAP module, perform the following steps:

1. Make sure that the anti-theft system is not armed or triggered.

2. Turn the ignition switch from OFF to RUN five times within ten seconds, ending in RUN. If the RAP module has successfully entered program mode, it will lock and then unlock all doors.

3. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.

4. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Diagnosis and Testing in this section.

5. Turn the ignition switch to the OFF position, or wait up to five minutes after step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.

mtg · Post by **mtg** » Sat Apr 25, 2009 4:42 pm

Thanks ERR that worked perfectly still don't know why this happened on both one stays at home and no power losses so i dont know

nexus_7 · Post by **nexus_7** » Sat Apr 25, 2009 5:41 pm

just happenes. happened to my moms infiniti a few months back for no reason.

Err · Post by **Err** » Sun Apr 26, 2009 7:46 pm

mtg wrote:Thanks ERR that worked perfectly still don't know why this happened on both one stays at home and no power losses so i dont know

You're welcome. Hopefully the programming sticks.