PCA Forums

I felt a lot of sorrow today as our complex came to a halt and the giant screens lit up with the news flash of this gutless cowardly attack on the USA. I for one completely agree with Vidman! This was a very well planned/ochestrated attack on the US and to my way of thinking someone or nation had to...

Rayzor, I would hold off on the Morpheus GF3 for the time being, the card is being pushed hard by the Australian distributor resulting in a fair few people now owning this card. This card does have a 2D quality issue that the Manufacturer has been made aware of. I do not own a Morpheus GF3 but i hav...

FP, have you given the 6.50 drvrs a run? if you have...have you noticed any improvements with them?

I'm d/l them now..

Thanks for the clarification dadx2mj, thanks MAC..

I'm using Nero 5.0.3.8 and have not had any problems with it burning iso's, very good little program..

Yo pimp daddy, That is a driver issue & i would normally say grab the latest drivers for the V3 and ensure you have 1.48 miniGL installed. PS: You could also try the WickedGL, FP would probably be the one to give you the lowdown on this, i'm not sure which way is better MiniGL 1.48 or WickedGL.....

Thanks MAC but i'm not sure i need a definite on this one..

Grab a thin broom like handle then cut down to size "approx 12'" then insert through centre of cd and use it as a pizza cutter to cut your home made pizzas..

What were the last official Detonator drivers before the 6.31's, for the life of me i cannot remember and i really need to try something out..

Hi xena & welcome

There's some good ones, Snatch i would have stabbed myself, Vidman ROTFLMAO that's priceless :D The one that i cannot seem to forget was when i was building a new P233 64meg sok7 job for someone, not thinking i started to screw in cards with power still running when i dropped a screw straight on to ...

Splitfire,

No problemo bro , that was my bad and indeed a mistake on my part.

Thanks for the heads up!

Yup!

and the Yamaha as UDMA16 I take from the above that you mean UDMA66. If you have 2 ide devices (one with UDMA66 & the other with UDMA33) on the same channel it will show the correct dma capability of each device at bootup though the device with UDMA66 will drop back to UDMA33 so as the mobo con...

While it's possible, it depends very much on the quality of your PC100.
Personally i would opt for PC133 and negate any headaches i may come across with the PC100 if the sticks are not up to scratch..